| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) reject short block-read responses in the GPIO accessors
adm1266_gpio_get() and adm1266_gpio_get_multiple() both compose the
pin-status word as
pins_status = read_buf[0] + (read_buf[1] << 8);
right after i2c_smbus_read_block_data(), guarding only against an
error return. A well-behaved device returns 2 bytes for
GPIO_STATUS/PDIO_STATUS, but the helper happily reports a 0- or
1-byte response too. If the device returns 0 bytes, both read_buf
slots are uninitialized stack memory; if it returns 1 byte, read_buf[1]
is.
The composed value then flows through set_bit() into the caller's
*bits in adm1266_gpio_get_multiple(), or into the return value of
adm1266_gpio_get(), and ends up in userspace via gpiolib (sysfs and
the char-dev ioctls). That leaks a few bits of kernel stack per
request on any device whose firmware glitch, bus error, or hostile
slave produces a short block-read response.
Add the missing length check to both call sites and surface a short
response as -EIO. |
| In the Linux kernel, the following vulnerability has been resolved:
netfs: Fix netfs_invalidate_folio() to clear dirty bit if all changes gone
If a streaming write is made, this will leave the relevant modified folio
in a not-uptodate, but dirty state with a netfs_folio struct hung off of
folio->private indicating the dirty range. Subsequently truncating the
file such that the dirty data in the folio is removed, but the first part
of the folio theoretically remains will cause the netfs_folio struct to be
discarded... but will leave the dirty flag set.
If the folio is then read via mmap(), netfs_read_folio() will see that the
page is dirty and jump to netfs_read_gaps() to fill in the missing bits.
netfs_read_gaps(), however, expects there to be a netfs_folio struct
present and can oops because truncate removed it.
Fix this by calling folio_cancel_dirty() in netfs_invalidate_folio() in the
event that all the dirty data in the folio is erased (as nfs does).
Also add some tracepoints to log modifications to a dirty page.
This can be reproduced with something like:
dd if=/dev/zero of=/xfstest.test/foo bs=1M count=1
umount /xfstest.test
mount /xfstest.test
xfs_io -c "w 0xbbbf 0xf96c" \
-c "truncate 0xbbbf" \
-c "mmap -r 0xb000 0x11000" \
-c "mr 0xb000 0x11000" \
/xfstest.test/foo
with fscaching disabled (otherwise streaming writes are suppressed) and a
change to netfs_perform_write() to disallow streaming writes if the fd is
open O_RDWR:
if (//(file->f_mode & FMODE_READ) || <--- comment this out
netfs_is_cache_enabled(ctx)) {
It should be reproducible even without this change, but if prevents the
above trivial xfs_io command from reproducing it.
Note that the initial dd is important: the file must start out sufficiently
large that the zero-point logic doesn't just clear the gaps because it
knows there's nothing in the file to read yet. Unmounting and mounting is
needed to clear the pagecache (there are other ways to do that that may
also work).
This was initially reproduced with the generic/522 xfstest on some patches
that remove the FMODE_READ restriction. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (lm90) Stop work before releasing hwmon device
Sashiko reports:
In lm90_probe(), the devm action to cancel the alert_work and report_work
(lm90_restore_conf) is registered in lm90_init_client() before
devm_hwmon_device_register_with_info() is called.
Because devm executes cleanup actions in reverse order during module
unbind or probe failure, the hwmon device is unregistered and freed first.
If lm90_alert_work() or lm90_report_alarms() runs in the window between
the hwmon device being freed and the delayed works being cancelled,
lm90_update_alarms() will dereference the freed data->hwmon_dev here.
Fix the problem by canceling the workers separately after registering
the hwmon device and before registering the interrupt handler. This ensures
that the workers are canceled after interrupts are disabled and before
the hwmon device is released. Add "shutdown" flag to indicate that device
shutdown is in progress to prevent workers from being re-armed. |
| In the Linux kernel, the following vulnerability has been resolved:
gfs2: fix use-after-free in gfs2_qd_dealloc
gfs2_qd_dealloc(), called as an RCU callback from gfs2_qd_dispose(),
accesses the superblock object sdp through qd->qd_sbd after freeing qd.
It does so to decrement sd_quota_count and wake up sd_kill_wait.
However, by the time the RCU callback runs, gfs2_put_super() may have
already freed sdp via free_sbd(). This can happen when
gfs2_quota_cleanup() is called during unmount: it disposes of quota
objects via call_rcu() and then waits on sd_kill_wait with a 60-second
timeout. If the timeout expires, or if gfs2_gl_hash_clear() triggers
additional qd_put() calls that schedule more RCU callbacks after the
wait completes, gfs2_put_super() will proceed to free the superblock
while RCU callbacks referencing it are still pending.
Add an rcu_barrier() before free_sbd() in gfs2_put_super() to ensure
all pending RCU callbacks (including gfs2_qd_dealloc) have completed
before the superblock is freed. |
| In the Linux kernel, the following vulnerability has been resolved:
iommu/vt-d: Block PASID attachment to nested domain with dirty tracking
Kernel lacks dirty tracking support on nested domain attached to PASID,
fails the attachment early if nesting parent domain is dirty tracking
configured, otherwise dirty pages would be lost. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: iptfs: preserve shared-frag marker in iptfs_consume_frags()
iptfs_consume_frags() transfers paged fragments from one socket buffer
to another but fails to propagate the SKBFL_SHARED_FRAG flag. This is
the same class of bug that was fixed in skb_try_coalesce() for
CVE-2026-46300: when fragments backed by read-only page-cache pages are
merged, the marker indicating their shared nature must be preserved so
that ESP can decide correctly whether in-place encryption is safe.
Apply the same two-line fix used in skb_try_coalesce() to
iptfs_consume_frags(). |
| In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gem: Fix phys BO pread/pwrite with offset
sg_page() returns struct page pointer not (void *) so the scaling
of pread/pwrite is wrong for phys BO and wrong parts of BO would be
accessed if non-zero offset is used.
Last impacted platform with overlay or cursor planes using phys
mapping was Gen3/945G/Lakeport.
(cherry picked from commit 3e49a2f85070b2fb672c1e0fdba281a4ea3aebe6) |
| In the Linux kernel, the following vulnerability has been resolved:
net: rds: clear i_sends on setup unwind
The RDS IB connection teardown path is written so it can run during
partial startup and on repeated shutdown attempts. It uses NULL
pointers to distinguish resources that are still owned from resources
that have already been released.
When rds_ib_setup_qp() fails after allocating i_sends but before
allocating i_recvs, the sends_out path frees i_sends without clearing
the pointer. A later shutdown pass can still treat that stale pointer
as a live send ring allocation.
Clear i_sends after vfree() in the error unwind path so the existing
shutdown logic continues to use the correct ownership state. |
| YAML::Syck versions before 1.47 for Perl allow a heap use-after-free via an anchor name reused as an anchors-table key in syck_hdlr_add_anchor.
In the bundled libsyck an anchor name allocated by syck_strndup is stored both as node->anchor, freed when the node is freed, and as the key in the parser's anchors table. Freeing the node frees the shared key, and a later anchor redefinition makes st_delete compare against the freed key, so st_strcmp reads freed heap memory. Anchors are a standard YAML feature and need no special flags, so this is reached on the default Load path.
Any caller that runs Load or LoadFile on an untrusted document that redefines an anchor reaches the read of freed memory. |
| mtr is vulnerable to Out-of-bound read vulnerability in ipinfo_lookup() function. An attacker who can influence the TXT response used for AS lookups can trigger this bug by returning a DNS response that is larger than 512 bytes and uses a crafted compression pointer in the answer NAME field. ipinfo_lookup() function uses the length of the response as the end-of-message boundary for dn_expand() function. The result is a reliable crash.
This issue exists in the mtr through version 0.96 and it was fixed in commit 48e1794414d338ce47abc0f27c25ade8788af9c3. |
| Kiota is an OpenAPI based HTTP Client code generator. Prior to 1.32.5, `kiota plugin add` and `kiota plugin generate` (with `-t APIPlugin`) emitted attacker-controlled static_template.file values from x-ai-adaptive-card and x-ai-capabilities into generated Microsoft 365 Copilot and Teams plugin manifests without path validation, allowing ../, absolute, rooted, UNC, Windows drive, or URI paths in response_semantics.static_template.file to cause path traversal or out-of-package file inclusion when the generated plugin was deployed. This issue is fixed in version 1.32.5. |
| Kiota is an OpenAPI based HTTP Client code generator. Prior to 1.32.5, Kiota resolved OpenAPI $ref values by fetching remote http(s) URLs and reading local absolute or out-of-tree file paths, allowing `kiota generate` on an attacker-controlled or attacker-influenced description to perform build-time SSRF, remote file inclusion, and local file inclusion by inlining external schemas such as REMOTE_KIOTA_PROP or Leaked into generated clients. This issue is fixed in version 1.32.5 by AllowedExternalOriginsStreamLoader and the --allowed-external-origins option. |
| Untrusted pointer dereference in Microsoft Office Excel allows an unauthorized attacker to disclose information locally. |
| ImageMagick before 7.1.2-26 and 6.9.13-51 contains a use-after-free vulnerability that occurs when freetype initialization fails: the method does not exit and continues to use memory that was already freed. This can be triggered during image processing and may lead to a denial of service. |
| FastGPT is a knowledge-based AI application platform. At commit 22ebfacbb43311e9b73294040ae0eb87390c6bba and earlier, artifacts built from untrusted pull request code in .github/workflows/preview-docs-build.yml and .github/workflows/preview-fastgpt-build.yml can be downloaded by privileged workflow_run jobs in .github/workflows/preview-docs-push.yml and .github/workflows/preview-fastgpt-push.yml, allowing attacker-controlled Docker images from the document/ tree or FastGPT build context to be pushed to GHCR and, for documentation previews, deployed with secrets.KUBE_CONFIG_CN. |
| Untrusted pointer dereference in Microsoft Office Excel allows an unauthorized attacker to disclose information locally. |
| Incorrect access of indexable resource ('range error') in Windows Sensor Data Service allows an authorized attacker to elevate privileges locally. |
| Untrusted pointer dereference in Windows DirectX allows an authorized attacker to execute code locally. |
| Untrusted pointer dereference in Windows Resilient File System (ReFS) allows an authorized attacker to elevate privileges locally. |
| LLaMA-Factory through 0.9.5 contains a remote code execution vulnerability that allows attackers with WebUI access to execute arbitrary Python code by supplying a malicious model path in the Chat or Training interfaces. The application passes user-supplied model path input unvalidated into AutoTokenizer.from_pretrained() and AutoModel.from_pretrained() with a hardcoded trust_remote_code=True parameter, causing the Hugging Face transformers library to fetch and execute arbitrary code from a remote or local model repository with the privileges of the server process. |
